Sonifex HY-03S Telephone Hybrid - Automatic Analogue TBU, Rack Mounted
The Sonifex HY-03S is a single automatic analogue TBU, 19" (48.3cm) rack-mount unit.
The analogue Sonifex HY-03 telephone hybrid is the replacement for the HY-02, which for many years has set the standard as an excellent value, high quality telephone hybrid.
The HY-03 retains many of the features of the HY-02 and adds some additional ones. Some of the features of the HY-03 include :
- Fully automatic - adapts to varying line conditions and has automatic signal limiting.
- Local and remote line hold switching - calls can be remotely switched through a mixing console.
- Momentary or permanent latching remotes can be enabled.
- Balanced mic/line input - 10k ohm balanced input selectable for 0dBu clean feed line, or microphone level with adjustable gain.
- Balanced output - 0dBu low impedance balanced output, with output gain adjustment.
- Mixed output - the output can be a mix of the caller and mic/line input signals for recording both sides of the telephone conversation.
- Integrated ring detector - automatic call answering after a pre-determined number of rings.
- Fitted with K-break disconnect detection as standard with an option for dial-tone disconnect using the optional HY-03DTD board. The HY-03DTD board can be configured to disconnect on recognizing the dial tone used in a specific country.
- Line limiter, bandpass filter and output noise gate with preset threshold providing low distortion crystal clear audio.
- 28dB typical line balance rejection.
- Built in power supply with switchable 115V, or 230V, mains input.
- BABT approval compliant with European PTT specifications.
Which Format Is Most Suitable?
The HY-03 analogue hybrids are available in three models :
- HY-03 Single free-standing automatic analogue TBU.
- HY-03S Single 19” rack mounted automatic analogue TBU with ringing detector.
- HY-03T Twin 19” rack mounted automatic analogue TBU.
Technical Specification For HY-03S |
||||||||
Audio Specification |
||||||||
Input Impedance - Line Mode (Clean Feed): | 10kΩ balanced 0dB | |||||||
Input Impedance - Microphone Mode: | 2kΩ balanced | |||||||
Clean Feed Limiting Input: | +4dBu | |||||||
Microphone Level Range: | From 74dB to 40dB adjusted by preset pot | |||||||
Bandwidth to Telephone Line: | 250Hz - 4kHz, -3dB ref 1kHz | |||||||
Telephone Line Impedance: | Nominally 600Ω | |||||||
Telephone Line Impedance Range: | 300Ω to 1500Ω | |||||||
Output Impedance: | 50Ω balanced floating 0dBu | |||||||
Output Level Range: | +8dB to -14dB adjusted by preset pot | |||||||
Rejection Ratio: | 45dB on 1kHz tone, typically 28dB on complex waveforms, reference peak level of 0dB | |||||||
Ring Detector Sensitivity: | 1 ring to 6 rings | |||||||
Power: | 230V 50Hz, or 115V 60Hz. 6W for HY-03. | |||||||
Connections |
||||||||
Mic/Line Input: | XLR 3 pin female with push button mic/line selection | |||||||
Line Output: | XLR 3 pin male | |||||||
Telephone Line: | RJ11 6/4 socket | |||||||
Telephone Handset/Instrument: | RJ11 6/4 socket | |||||||
Remotes: | 9-way D-type socket | |||||||
Power: | IEC mains (CEE22) | |||||||
Each unit is supplied with 1 x RJ11 to RJ11 telephone line lead, 1 x RJ11 to BT plug telephone line lead, 1 x BT handset socket to RJ11 plug adapter, IEC mains lead fitted with moulded mains plug, handbook and warranty card. | ||||||||
Order Code | Description |
Height |
Width |
Depth* |
Total Nett |
Total Gross Weight |
||
HY-03S | Automatic analogue TBU, 19” rack mounted |
4.5cm (1U) |
48.3cm |
17.5cm |
1.30kg |
2.1kg |
||
HY-03S boxed |
6.8cm |
58.8cm |
27cm |
|||||
*Depth is measured from the front to the end of the connectors fitted to the back of the unit. Note: If you are ordering the HY-03 for use in the USA, add the word “US” after the product code. If you are using the HY-03 with the Broadcast Bionics PhoneBox system, then add the word ”BB” after the product code. The HY-03 uses different circuitry for these systems. |
||||||||
Accessories |
||||||||
Order Code | Description | |||||||
HY-03DTD | Dial tone detect add-on board | |||||||
HY-03CON | Front panel conversion kit, HY-03S 19” (48cm) rack-mount front to HY-03 free standing | |||||||
HY-03TCON | Front panel conversion kit, HY-03 or HY-03S, to HY-03T 19” (49cm) rack-mount front | |||||||
HY-02EC | Eurocard version of HY-02 analogue TBU (non RoHS) |
Titel | Sorte | Größe | Herunterladen |
---|---|---|---|
sonifex-hybrids-brochure-18.pdf | 1.83MB | Herunterladen |